The Lego Star Wars Clone Scout Walker 75261 with only over two hundred Lego pieces is a perfect beginner level model to recreate different battle scenes from the movies. When you add the five premium LED lights and the handmade accessories from the Briksmax light kit, be assured that your Lego model will never be out of focus or overshadowed in dark.
The 20th Anniversary edition of the Lego Star Wars series introduced several new exciting models from this epic movie saga, the craze of which can never falter. The Clone Scout Walker 75261 set is one such model from the series made up of 250 Lego pieces. This kid-friendly model is an upgrade from the Clone Scout Walker 7250 set released in 2005 and is suitable for anyone above six years old. What makes the model with three Minifigures so exciting is adding the high-quality lighting kit from Briksmax that comes in a plug-and-play design to install easily by anyone with any skill level.
Specialties Of Clone Scout Walker 75261 Set
The Lego Star Wars set lights should not be added before completing the entire model because the lights and accessories are very small and delicate that makes them prone to damage or mix up with Lego pieces if not careful. To avoid any complications while adding lights and choking hazards among kids, finish assembling the model and get three batteries for the battery pack.
With lighting kit, you can highlight the AT-RT vehicle with an antenna that stands over eight inches in height with a length of five inches and a width of two inches. The AT-RT comes with turning turret, posable legs, stud shooter on the front and a top seat for the Minifigure.
There are three Minifigures of the Kashyyyk Trooper with the blaster, the Wookiee Warrior with the rifle and the special Darth Vader figure with lightsaber from 1999 with the detachable commemorative display stand representing the original Minifigure of 1999 with the 20th-anniversary logo.
The Lego lights will also highlight the Dwarf Spider Battle Droid having stud shooter, blaster, movable antenna, posable legs and non-shooting gun in trench section. It stands three inches in height with a length and a width of two inches respectively. Its head decoration was added in April 2019.
Highlighting Clone Scout Walker 75261 With Light Kit
Anyone above six years old can add accessories and light for Lego Clone Scout Walker 75261 with or without prior electrical knowledge. The light kit comes with a manufacturer warranty of two years from the date of delivery.
You will get two random colored Lego plates that can be used for customization. The illustrated instruction book will guide you through each installation step described in the universal language. The user guide will be helpful in further installation.
One white light strip, one warm white 15cm LED, one slow-flashing 15cm red LED and two 30cm red LEDs are given for lighting Lego. Use the brick separator to insert one 5cm connecting wire between the Lego stubs.
Set up a 6-port expansion board with an Adhesive Square. Insert batteries in the Oval CR2032 battery box and connect the 30cm power cable to the hub. Make sure that the main power is below 5V to prevent electrical hazards.
You should always test each light and accessory after unboxing the light kit. If any item is missing, not working properly or broken, you can get it replaced by sending it back within a week.
